MultiControl

Application Area

Zero-pressure accumulation conveying (ZPA) of many zones. Control of the Interroll Transfer and the Interroll High Performance Divert. Control of RollerDrive EC310 in applications without zero-pressure accumulation conveying.

Description

The MultiControl is a four-zone control. This means that up to four RollerDrive EC310 and four zone sensors can be connected. The use of Y-lines enables connecting four additional inputs or outputs. The connections can be configured individually.

The MultiControl is multiprotocol-capable control. The fieldbuses PROFINET, EtherNet/IP or EtherCat can be used by simply toggling them. With help of the MultiControl, sensors and RollerDrive are directly integrated in to the field bus level. No additional sensor/actuator level is necessary. A standard ribbon cable is used for power connection. The ribbon cable can be cut to the correct length and can be connected very quickly using the penetration technology of MultiControl.

Two separate power circuits allow safe powering off of the RollerDrive while bus communication remains active.

The addressing and naming is done over PLC software, a web browser menue, or with the Interroll Teach-In method. With the Teach-In method, automatic addressing and configuration of all MultiControl is possible. In addition, the sequence of all MultiControls in the conveyor line can be determined. This saves time during the commissioning on site.

Download PDF

Two separate power circuits allow safe powering off of the RollerDrive while bus communication remains active.

What is new?

- Enhanced protection against wrong polarity of the power wiring

- Power output on I/O protected against short circuits via resetable fusing

- Safe powering-off of the RollerDrive while bus remains active

- Protection against electrical noise

- Process Images facilitates finding the optimum solution between variety of data used and PLC capacity

Voulez-vous être contacté par notre service commercial?

Contactez-moi